Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision		 Previous revision
dsa:fft [2024/05/29 15:23] – dsain_go-ci.comdsa:fft [2024/07/17 19:39] (current) – [Input Channels] dsain_go-ci.com
Line 2: Line 2:
 Follow the guided steps below on how to set-up a FFT Analysis in EDM to use with Spider hardware.\\ Follow the guided steps below on how to set-up a FFT Analysis in EDM to use with Spider hardware.\\
 ===== Create Test ===== ===== Create Test =====
 +
 <slider :dsa:pasted:20240521-142436.png> <slider :dsa:pasted:20240521-142436.png>
 <slider :dsa:pasted:20240521-142445.png> <slider :dsa:pasted:20240521-142445.png>
Line 38: Line 39:
 The input channels will now need to be set up. All sensors will to be properly configured before testing. The Input Channels menu can be found through **Setup → Input Channels**.\\  {{ :dsa:pasted:20240521-152103.png }}\\   The input channels will now need to be set up. All sensors will to be properly configured before testing. The Input Channels menu can be found through **Setup → Input Channels**.\\  {{ :dsa:pasted:20240521-152103.png }}\\  
  
-**Measurement Quantity**\\  Defines the physical unit that will be measured by the sensor connected to the channel.\\**Sensitivity**\\  Sets the proportionality factor for the measurement (millivolts per engineering unit) given as a parameter of the sensor.\\+**Measurement Quantity**\\  Defines the physical unit that will be measured by the sensor connected to the channel.\\ 
 +**Sensitivity**\\  Sets the proportionality factor for the measurement (millivolts per engineering unit) given as a parameter of the sensor.\\
  
 **Input Mode**\\  There are six modes in which the inputs can operate:\\ **Input Mode**\\  There are six modes in which the inputs can operate:\\