Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision		 Previous revision
vds:machinebuilder [2026/06/25 16:42] – reid_go-ci.comvds:machinebuilder [2026/07/06 23:59] (current) – wkemphaus_go-ci.com
Line 7: Line 7:
 {{:vds:machine_builder_icons.png?400|}} {{:vds:machine_builder_icons.png?400|}}
  
-===Machine Class=== \\ The machine class represents the full model of the machine.  Includes RPM and speed variation information.  Automated diagnostics are run at the machine class level \\ +**Machine Class: **  The machine class represents the full model of the machine.  Includes RPM and speed variation information.  Automated diagnostics are run at the machine class level \\ \\ 
-===Composites=== +**Composites: ** composites are composed of several components and are used for inter-component issues i.e. pulleys and gear compressors. \\ \\ 
 +**Components:**  collection of elements on a single shaft \\ \\
  
-composites are composed of several components and are used for inter-component issues i.e. pulleys and gear compressors. \\ +**Elements:** a mechanical part i.e. bearings, fans, and motors\\
-===Components=== \\ collection of elements on a single shaft +
- +
-===Elements=== a mechanical part i.e. bearings, fans, and motors+
  
 ====Machine Construction==== ====Machine Construction====
  
-====Diagnostic Features====+{{:vds:machine_drag.png?|}} 
 + 
 +{{:vds:drag_next_to_bearing.png?400|}}{{:vds:drag_over_bearing.png?400|}} 
 + 
 +Component and element features can be edited by selecting either the component or sub element in the demo window or property selection.  To select an element in the demo window 1st click on the part to select the component then click again to enter element selection. 
 + 
 +{{:vds:component_highlight.png?400|}}{{:vds:element_highlight.png?400|}} 
 + 
 +Component settings allows you to set the speed component. 
 + 
 +{{:vds:element_settings.png?400|}}
  
 +Element settings allows for you to select if the element is a pickup point and adjust diagnostic features as well as input information such as forcing orders and pole count.